Comtech EF Data HPOD Outdoor SSPA Amplifier Systems
Available in C-, Ku-, or X-Band configurations
HPOD High Power Outdoor SSPA Amplifier System
Comtech EF Data’s (CEFD) HPOD series of High-Power Outdoor C-, X-, and Ku-Band Solid-State Power Amplifiers (SSPAs) provide a cost-effective, more linear replacement for TWT amplifiers in satellite communications terminals. The HPOD delivers its rated power, guaranteed at the 1 dB compression point to the transmit waveguide flange.
Field Replaceable Power Supply
Recognizing that the MTBF limiting factor for almost all electronic equipment is the power supply, these amplifiers provide for easy field replacement. Simply disconnect the AC mains, release the captive fasteners, and remove the supply from the SSPA module.
SSPA Advantage
Each SSPA is constructed with highly reliable GaAs FETs. With third order intermodulation products from 4 to 6 dB better than TWT ratings, the CEFD unit replaces TWTs with saturated power levels of up to twice the rated output. These SSPAs also provide an MTBF that is 4 to 5 times greater than the typical TWT MTBF.
Functional Description
The High Power solid state amplifier consists of an SSPA module with the Monitor/Control Processor (MCP), a field replaceable power supply, and a field replaceable fan assembly. The amplifier features a Comtech EF Data low-loss combining technique and MCP-based temperature versus gain compensation.
Redundant Systems
Designed from the start to provide cost-effective 1:1 or 1:2 systems. Redundant system control is built into the unit, eliminating an external controller with its associated cabling. This provides a cost benefit to our customers both at initial purchase and at installation.
Higher Power Through Phase Combining
Comtech EF Data’s phase-combined systems allow the outputs of two amplifiers to be summed together. A “normal” 1:1 system using 300 W amplifiers provides 300 W of output power (the offline unit’s capabilities are unusable). The same amplifiers in a 1+1 phasecombined system will provide 600 W of output power in normal operation, and a “soft failure” state of 300 W. If no degradation on failure can be accommodated, a third amplifier can be added to form a 1:2 phase-combined system.
Optional “Smart BUC” Functionality
Our unique approach to L-Band/RF frequency conversions eliminates DC and 10 MHz from the input coax. This greatly simplifies redundant and multi-carrier operation. It offers full 13.75 to 14.5 GHz Ku-Band coverage and supports industry standard FSK modem/BUC communications. The optional BUC can lock to an external or internal reference oscillator.
Feature Packed
The SSPAs come equipped with useful features that other manufacturers offer as options. Included in each unit’s base price are temperature compensation, sample ports, power monitor, field-replaceable power factor corrected supply, and full remote monitor and control capabilities.
C-Band HPOD Specifications |
|
Output |
|
Frequency |
5.850 to 6.425 GHz |
Phase Combined Systems P1dB (Psat ), Watts |
400(500) |
Mute |
-60 dBc |
Impedance |
50O |
VSWR |
1.25:1 Maximum |
Connector |
CPR-137G Waveguide |
Gain |
|
Linear |
70 dB min, 75 dB typical |
Adjust |
20 dB in 0,25 dB steps |
Full Band |
± 1.0 dB |
Per 40 MHz |
± 0.25 dB |
-40 to +55°C |
± 1.0 dB |
Third Order Intermodulation |
|
Products |
-30 dBc typical, -25 dBc max @ 3 dB total back-off from rated P1dB (two tones, δf = 1 MHz) |
AM to PM Conversion |
|
2° typical, 3.5° maximum at rated output |
|
Group Delay (per 40 MHz) |
|
Linear |
±0.03 ns/MHz |
Parabolic |
±0.003 ns/MHz² |
Ripple |
±1.0 ns peak to peak |
Spurious |
|
Second Harmonic |
-60 dB dBc max @ 1 dB below rated output |
Impedance |
50 O |
Noise Figure |
8 dB typical, 10 dB maximum @ maximum gain |
VSWR |
1.25:1 Maximum |
Connector |
Type N |
Sample Ports |
|
Output Sample |
Type N, 50O, -40 dBc nominal |
Input Sample |
Type N, 50O, -20 dBc nominal |
Remote Control |
|
Com Port |
RS-485 or RS-232 |
Alarms |
|
Summary Fault |
Form C |
Environmental |
|
Operating Temp. |
-40° to +55°C (-40° to 131°F) |
Non-Operating Temp. |
-50° to +75°C (-58° to 167°F) |
Operating Humidity |
0 to 100% condensing |
Altitude |
10,000 ft above sea level (derated 2°C/ 1000 ft AMSL) |
Power Requirements |
|
180 to 264 VAC, 47 to 63 Hz |
|
Physical |
|
Dimensions (L x W x H) |
26.77 x 17.88 x 11.49 inches |
Weight |
75 lbs (34 kg) nominal |
For X-Band and Ku-Band specifications, please see datasheet. |
Video Broadcast, Satellite Teleports, Military Communications, Internet Access Services, Disaster communications, Telco Restoral Services