Comtech CDMER-625A Advanced Satellite Modem

Comtech CDM-570A

Comtech EF Data CDM-625A-EN Advanced Satellite Modem with AES Encryption

Comtech CDM-570A

Comtech EF Data DMD1050TS L-Band Next Generation Satellite Modem Board

SKU
CDMER-625A
Comtech CDMER-625A Advanced Satellite Modem is available to buy in increments of 1

Meets all MIL-STD-810G requirements including 510-I (Blowing Dust), 510-II (Blowing Sand) and 509 (Salt Fog).

CDMER-625A Environmentally Resistant Advanced Satellite Modem

The Comtech CDMER-625A is a highly Environmentally Resistant (ER) satellite modem that  offers extensive added protection for aggressive operating environments that have a higher concentration of dust, sand and salt. The ER version uses an application of Urethane Conformal Coating (CC) and critical interface protective covers for enhanced protection against dust, sand and salt. Special protective Conformal Coating and protective covers have been designed to ensure that the CDMER-625A meets MIL-STD-810G requirements including Method 510 Procedure I (Blowing Dust), Method 510 Procedure II (Blowing Sand) and Method 509 (Salt Fog). Both the CC and protective connector covers are non-nutrient fungal growth materials. The ER version also provides an extended operating temperature range of 0 to 60º C. The ER version is not designed to be used in an un-controlled environment or outdoor application. The ER version carries the same two year standard warranty as other Comtech EF Data products

With support for the revolutionary DoubleTalk Carrier-in-Carrier bandwidth compression, VersaFEC Forward Error Correction (FEC), additional rolloffs and advanced packet processing, the CDMER-625A provides exceptionally reliable spectral purity and satellite space segment cost reductions under all conditions. These combinations of advanced technologies enable multi-dimensional optimization, allowing satellite communications users to: 

arrow Minimize operating expenses (OPEX)

arrow Maximize throughput without using additional transponder resources

arrow Maximize availability (margin) without using additional transponder resources

arrow Minimize capital expenses (CAPEX) by allowing a smaller BUC/amplifier and/or antenna

arrow Or, a combination to meet specific business needs

The modems are available with 70/140 MHz or L-Band IF and EIA-530/-422, V.35, sync EIA-232 and G.703 T1/E1 data interfaces. The CDMER-625A includes a high-performance packet processor for IP-centric applications.

Comtech CDMER-625A Modem RF Interface Panel

Key Features

arrow Environmentally Resistant (ER)

arrow DoubleTalk Carrier-in-Carrier bandwidth compression

arrow Carrier-in-Carrier Automatic Power Control

arrow VersaFEC-2 High Performance LDPC with Adaptive Coding and Modulation (ACM), Short Block and Long Block

arrow VersaFEC FEC with Adaptive Coding and Modulation (ACM)

arrow 5%, 10%, 15%, 20%, 25% and 35% Filter Rolloff

arrow Packet Processor with header compression, payload compression, advanced Quality of Service (QoS) and Managed Switch Mode with VLAN support

arrow Integrated 4-port managed Ethernet switch with VLAN and QoS

arrow Jumbo frame support

arrow Dual Band Capability: 70/140 MHz and extended L-Band (950 – 2250 MHz) in same unit 

arrow Data Rate: 18 kbps to 25 Mbps

arrow Symbol Rate: 18 ksps to 12.5 Msps

arrow Modulation: BPSK, QPSK/OQPSK, 8PSK/8-QAM/8-ARY, 16-QAM/16-ARY, 32-ARY

arrow FEC: Viterbi, Sequential, Concatenated Reed Solomon, TCM, Turbo Product Code (TPC) (IESS-315 Compliant), LDPC Code, VersaFEC (low-latency LDPC) and VersaFEC2 (high performance LDPC)

Doubletalk Carrier-in-Carrier

CDMER-625A carrier-in-carrier diagram

arrow Mobile Backhaul

arrow G.703 Trunking

arrow IP Trunking

arrow Offshore & Maritime Communications

arrow Enterprise

arrow Communications on-the-Move

arrow Satellite News Gathering