Comtech CDM-570A-IPEN & CDM-570AL-IPEN 3xDES Encryption Satellite Modems
Enrypted L-Band Input, Variable rate from 2.4 Kbps to 9.98 Mbps
CDM-570A-IPEN & CDM-570AL-IPEN 3xDES Encryption Satellite Modems
The Comtech CDM-570A-IPEN and the CDM-570AL-IPEN are IP-centric satellite modems with data encryption that provide industry leading performance and flexibility in a 1RU package. With their innovative architecture and support for advanced capabilities, CDM-570A-IPEN and CDM-570AL-IPEN allow for efficient IP networking and transport over satellite links while supporting a wide range of applications and network topologies. In addition to the 10/100Base-T Ethernet interface, a wide range of data interfaces are available to support legacy applications and assist in migrating from legacy to IP transport. The advanced FPGA-based architecture along with the internal Flash memory allows for easy field upgrades via the Ethernet port.
Features
- 3xDES Encryption for transport security
- Integrated high performance Packet processor with 10/100Base-T Ethernet traffic port
- Static IP routing for unicast and multicast
- Advanced Quality of Service (QoS)
- Header and payload compression for maximum efficiency
- IGMP v1 and v2
- VLAN capability with 802.1Q compliant QoS
- Support for mesh, star and hybrid network topologies
- Vipersat Management System (VMS) integration
- DoubleTalk Carrier-in-Carrier bandwidth compression with Automatic Power Control (CnC-APC)
- VersaFEC-2 High Performance LDPC
- VersaFEC low latency LDPC
- VersaFEC-2 and VersaFEC Adaptive Coding & Modulation (ACM) for point-to-point IP Circuits
- Optimized Transmit Filter Rolloff: 5%, 10%, 15%, 20%, 25% and 35%
- Data rate range from 2.4 kbps to 10.239 Mbps
- CDM-570A-IPEN: 50 to 90 or 100 to 180 MHz IF range
- CDM-570AL-IPEN: 950 to 2250 MHz IF range
Data Encryption
Configurable on a per route basis, the modems supports 3xDES data encryption for transmission security to prevent unauthorized access to data transmitted over the satellite link. Encryption is configurable on a per route basis. Encryption is not available if using legacy serial or G.703 data interfaces
Frequency Range |
CDM-570A-IPEN & CDM-570AL-IPEN: 50 to 90 or 100 to 180 MHz, 100 Hz resolution CDM-570L & CDM-570L-IP: 950 to 2000 MHz, 100 Hz resolution |
Data Interfaces |
EIA-422/-530 DCE, V.35 DCE, Sync EIA-232, 10/100Base-T Ethernet (option), G.703 T1 balanced (option), G.703 E1 balanced or unbalanced (option) |
Data Rate Range (See user manual for details) |
2.4 kbps to 9.98 Mbps (depending on modulation, FEC and framing), 1 bps step with fully independent TX and RX rates |
Modulation & FEC |
Data Rate Range |
5/16 BPSK TPC |
2.4 kbps to 0.937 Mbps |
21/44 BPSK TPC |
2.4 kbps to 1.430 Mbps |
1/2 BPSK |
2.4 kbps to 1.500 Mbps |
1/2 QPSK/OQPSK |
4.8 kbps to 3.000 Mbps |
3/4 QPSK/OQPSK |
7.2 kbps to 4.500 Mbps |
7/8 QPSK/OQPSK |
8.4 kbps to 5.250 Mbps |
2/3 8PSK TCM |
8.7 kbps to 4.400 Mbps |
21/44 QPSK/OQPSK TPC |
4.8 kbps to 2.860 Mbps |
3/4 QPSK/OQPSK TPC |
7.2 kbps to 4.500 Mbps |
7/8 QPSK/OQPSK TPC |
8.4 kbps to 5.250 Mbps |
0.95 QPSK/OQPSK TPC |
9.1 kbps to 5.666 Mbps |
3/4 8PSK/8-QAM TPC |
10.8 kbps to 6.750 Mbps |
7/8 8PSK/8-QAM TPC |
13.6 kbps to 7.875 Mbps |
0.95 8PSK/8-QAM TPC |
15.3 kbps to 8.500 Mbps |
3/4 16-QAM TPC |
14.4 kbps to 9.000 Mbps |
7/8 16-QAM TPC |
16.8 kbps to 9.980 Mbps |
Uncoded BPSK |
4.8 kbps to 3.000 Mbps |
Uncoded QPSK/OQPSK |
9.6 kbps to 5.000 Mbps |
FEC Options Viterbi |
Rate 1/2 BPSK, QPSK/OQPSK Rate 3/4 and 7/8 QPSK/OQPSK and 16-QAM w/RS |
TCM |
8PSK 2/3 (Closed network – not IESS-310) |
Turbo Product Coding |
Rate 21/44 BPSK, 5/16 BPSK, Rate 21/44 QPSK/OQPSK Rate 3/4 and Rate 7/8 QPSK/OQPSK, 8PSK/8-QAM and 16-QAM Rate 0.95 QPSK/OQPSK and 8PSK/8-QAM |
Reed-Solomon |
Proprietary 220/200 and 200/180 modes available |
Uncoded |
BPSK, QPSK/OQPSK |
M&C Interface |
EIA-232, EIA-485 (2-or 4-wire), Ethernet 10/100Base-T (dependent on operational mode) |
Input/Output Impedance |
CDM-570 & CDM-570-IP: matched for 50/75 n, BNC connector CDM-570L & CDM-570L-IP: transmit and receive 50 n, female Type N connector |
External Reference Input |
1, 2, 5, 10 or 20 MHz, BNC connector |
Form C Relays |
TX, RX traffic alarms and unit faults |
CDM-570A-IPEN & CDM-570AL-IPEN |
CDM-570L & CDM-570L-IP |
|
||
Frequency Stability |
±1 ppm, 0º to 50ºC (32º to 122ºF) |
±0.06 ppm, 0º to 50ºC (32º to 122ºF) |
||
Output Power |
0 to –25 dBm, 0.1 dB steps |
0 to –40 dBm, 0.1 dB steps |
||
Accuracy |
± 0.5 dB over frequency and temperature |
± 1.0 dB over frequency and temperature |
||
Phase Noise |
< 0.75 degrees RMS double-sided, 100 Hz to 1 MHz |
< 1.2 degrees RMS double-sided, 100 Hz to 1 MHz |
||
Output Spectrum/ Filtering |
Meets IESS-308/-309 power spectral mask |
|||
Harmonics and Spurious |
< -55 dBc/4 kHz (typically < -60 dBc/4 kHz) |
|||
Transmit On/Off Ratio |
55 dB minimum |
|||
External TX Carrier Off |
By TTL LOW signal, or RTS |
|||
TX Clock Options |
Internal (SCT), external (TT), loop timing with symmetric or asymmetric operation (data interface dependent) |
|||
CDM-570 & CDM-570-IP |
CDM-570L & CDM-570L-IP |
|
||
Input Power Range |
-30 to -60 dBm |
-130 + 10 log symbol rate, dBm (minimum) -90 + 10 log symbol rate, dBm (maximum) |
||
Max Composite Level |
+35 dBc, up to -5 dBm absolute max. |
+40 dBc, up to -10 dBm absolute max. |
||
Acquisition Range |
± 1 to ± 32 kHz, 1 kHz step |
± 1 to ± 32 kHz, 1 kHz step, symbol rate <= 625 ksps ± 1 to ± 200 kHz, 1 kHz step, symbol rate > 625 ksps |
||
Acquisition Time |
Highly dependent on data rate, FEC rate, and demodulator acquisition range. Example: 120 ms average at 64 kbps, Rate 1/2 QPSK, ± 10 kHz acquisition sweep range, 6dB Eb/No |
|||
Receive Buffer |
512, 1024, 2048, 4096, 8182, or 16384 bits |
|||
Receive Clock Options |
Buffer disabled (RX satellite), buffer enabled (symmetric or asymmetric operation) (data interface dependent) |
|||
Clock Tracking |
± 100 ppm minimum |
|||
Monitor Functions |
Eb/No, frequency offset, BER, buffer fill status, RX signal level |
|||
Temperature |
Operating: 0 to 50°C (32 to 122°F) |
|
Storage: -25 to 85°C (-13 to 185°F) |
|
|
Power Supply |
100 to 240 VAC, 50/60 Hz -24 VDC (HW option) -48 VDC (HW option) |
|
Power Consumption (See Manual) |
CDM-570: 29 W typical (32 W max.) CDM-570-IP: 37 W typical CDM-570L: 29 W typical (32 W max.) w/o BUC CDM-570L-IP: 37 W typical w/o BUC |
|
Dimensions (height x width x depth) |
CDM-570-IP: 1.75” x 19” x 12” (4.4 x 48.3 x 30.5 cm) CDM-570L-IP: 1.75” x 19” x 16” (4.4 x 48.3 x 40.6 cm) |
|
Weight |
CDM-570 & CDM-570-IP: 6 lbs (2.7 kg) CDM-570L: 7 lbs (3.2 kg) (without BUC P/S) CDM-570L & CDM-570L-IP: 16 lbs (7.2 kg) including 150 W BUC power supply |
Typical Users
- • Enterprise
- • Internet Service Providers
- • Satellite Service Providers
- • Offshore & Maritime
- • Mobile Operators
Common Applications
- • Mobile Backhaul
- • Communications on-the-Move
- • Disaster Recovery & Emergency Communications
- • Enterprise
- • Offshore & Maritime Communications
- • Satellite News Gathering